cool do you provide instructions on how to intall??

There are a couple photos in the Member Bikes wall of fame, 5th page, where Srinath shows you where to cut the stock pipe.  The rest is pretty much simple.  Clean the area on the stock pipe with a sander/grinder, some WD-40.  Zip tie a piece of car tire to the right leg of the center stand.  Slip the mid-pipe on.

Quote from: vfrocketcool do you provide instructions on how to intall??

OK if I have to provide instructions to install ... OK I have madea lousy product. One look at the flange and anyone that's seen a GS knows where to cut it. Yea That chunk of car tire to centerstand to keep it off your left foot ... Tht's original. But the pipe ... not at all ... Anyway there is pics in that link I posted a few posts earlier in this thread.
Cool.
Srinath.

sorry didnt mean to upset you.

Quote from: vfrocketsorry didnt mean to upset you.

No not at all ... the flange I first made was just pages and pages of instruction ... cut the pipe into a C ... blah blah blah ... only I could make sense of it ... I then decided to make somehting that just goes on easy ... cis I realised exhaust pipes get bent a little in crashes etc ... common to be an inch+ off ... my old flange was just too close to the swingarm to accomodate that ... these ... rotate a bit this way or that and fit it ... easy ...
Cool.
Srinath.

Ok these are a go. I have numbers verbally committed. I guess now just buy a wileyco and send me your details (like address - choker etc) and $$ ...
Flange is $40 ... add shipping ($6-8)
Addess for check is Srinath seshadri, 9227 swallow tail lane, Charlotte NC 28269.
Paypal is Seshadri_srinath@hotmail.com - add $2 if paypal.
The Flanges will get started next week middle or end. till then you can add yourself to the list ... just buy wileyco before they sell out. They had like 20 at last check. I can make 20 if needed ... just dont want to make more ... cos once wiley co is sold out ... flanges are worthless ...
Cool.
Srinath.