I installed a set of after markert blinkers.  I tested a single blinker before intalling the other 3 and it worked fine.  Now that all 4 are on there is a problem.  They will only blink when the engine is running.  When I hit the turn signal switch all 4 blink (like hazard lights) and the dash light does not come on.  I did a good job on the wiring and it is hooked up correctly.  Everything with the bike runs fine.  My guess is that the left control cluster is toast.  I dumped the bike a month back and the left side took a hit.  I just about got it all fixed and now this happens   

 Are they regular filament bulbs or LED's ?

Drumroll please...............


and the envelope................


The Mighty Carnac predicts.........


LEDs.

For information on the general operation of your TS circuit and what LEDs will do to it, you might want to read THIS FAQ.

You might want to read over THIS THREAD for one solution to the problem.

thanx for the help.  I will try the fix mentioned, if not I will get some filament bulb signals and try again.