will these fit?

http://cgi.ebay.com/ebaymotors/7-8-Clubman-Handle-Bars-New-Triumph-Cafe-Bar_W0QQcmdZViewItemQQcategoryZ35574QQihZ009QQitemZ190234309168QQrdZ1QQsspagenameZWDVW

yep thats what I got

awesome

just purchesed them woot!

Quote from: mach1 on July 06, 2008, 12:43:06 PM
yep thats what I got

Do you have a pic of them on the bike?

give me a few min..

here yah go

how much different, from stock, is the riding position?

about 5 or 6 inches lower than stock. or you can turn your bars upside down it about a few inches lower than that

i might have to buy a set

can you flip your stock bar and be fine? or do they not clear the shock tubes?

sorry im picking up my first GS this weekend

they wont clear the top triple. clubmans are cheap ebay has they in chrome and black.

ok thanks

Do you guys notice that the bars flex?
I used to have a set of clubmans like that, but I found under "spirited" riding, the bars would flex and after about a season and a half, I could see stress marks on the chrome. 

well i'm getting mine today but not sure if i get the risers yet....

i'll post pictures as soon as i get them on my bike

GSRIDER: i'll give u a review on it after i ride around with it for a week or two and see if the bars will flex

              what is spirited riding lol    i'm slow

mach1 what kind of bar end weights are those?

Quote from: mach1 on July 07, 2008, 05:31:39 PM
they wont clear the top triple. clubmans are cheap ebay has they in chrome and black.

they look really sharp

pardon my newbness - but what needs to be done to install them if they won't clear the triple? 

I dont know what barends those are but cyclegear had them on the shelf for 12.99+tax.

As far as modding stock bars to fit the top triple you would need to cut if in half and extend the center section, clubmans dont need to be modded to fit a GS if your bike has stock fairings than risers need to be used to clear the fairings, If you bike is naked than no risers are needed for the ones from ebay.

oh man u serioius naked bikes don't need risers X_X CRAP ghey i bought risers for no reason then 

yeah nakeds dont need them unless you dont like how low they are you can keep the risers just in case

would you have to get the holes drilled in those to get all the handlebar stuff on there?  can you get that done at the local stealership?

Yeah holes need to be drilled I cut My tabs off whe I had my clip-ons so I didnt drill these. I added some DS tape and mine are fine. I would go to the dealer fr drilling holes in your bars cause they can screw up and misalighn the holes. Just get a small drill bit and a punch and DIY.