More information about these can be found using the below links.

http://www.vortexracing.com/index.php?submenu=Products&src=gendocs&ref=Clipons&category=Products

http://cgi.ebay.com/ebaymotors/New-Vortex-Clip-Ons-Handlebars-Suzuki-GS-500-Silver-_W0QQcmdZViewItemQQitemZ360189811557QQptZMotorcyclesQ5fPartsQ5fAccessories#ht_1546wt_1165

SOLD

BUMP

How much did they change riding position?

What is the diameter of the actual bars?
I just got a 92 GS500F-N Canadian model with factory clip ons. (only 1989 in the US had clip ons). I want to replace the bars and if the diameter of your bars is the same, I'll take them. The bars have some slight bends so I'd like to put on new bars.
The existing bars are about 10" long and 7/8" diameter.

Quote from: tozilla on August 25, 2010, 07:37:38 PM
How much did they change riding position?

It changes the riding position to a more "sporty" forward lean

Quote from: adidasguy on August 26, 2010, 12:01:54 AM
What is the diameter of the actual bars?
I just got a 92 GS500F-N Canadian model with factory clip ons. (only 1989 in the US had clip ons). I want to replace the bars and if the diameter of your bars is the same, I'll take them. The bars have some slight bends so I'd like to put on new bars.
The existing bars are about 10" long and 7/8" diameter.

I'm not certain of the diameter, I would check with suzuki

Suzuki would not know what you are selling since you are selling a non-suzuki after market part.
You measure the diameter of the bars you are selling to know what size they are.
I know the Suzuki bars are 3/4" in diameter because I measured the ones on my bike. I was asking what the diameter is of the bars you are selling.
But that's OK. I'll order bars elsewhere. I just needed the bars and really didn't need the clip-on adapters.

I replaced my '89 clipon bars with woodcraft clipon bar replacements.  Same diameter, only $30 new.  The vortex bars will likely work as well, since they all seemed to be the same size, but the woodcraft bars definitely work.



http://gstwins.com/gsboard/index.php?topic=52450.msg592545

Quote from: adidasguy on August 26, 2010, 01:51:16 PM
Suzuki would not know what you are selling since you are selling a non-suzuki after market part.
You measure the diameter of the bars you are selling to know what size they are.
I know the Suzuki bars are 3/4" in diameter because I measured the ones on my bike. I was asking what the diameter is of the bars you are selling.
But that's OK. I'll order bars elsewhere. I just needed the bars and really didn't need the clip-on adapters.

Sorry I misunderstood your question.

SOLD!!!