Well it's running again!    The replacement movement did the trick.

The shaft on the movement was a little too long, so I had to add a gasket on the front to pull the movement back a couple of mm. The only problem with that is now the plastic "catches" don't really lock down the movement properly. Oh well, at least it finally works!

Quote from: beRto on April 18, 2012, 07:36:27 PM
Well it's running again!    The replacement movement did the trick.

The shaft on the movement was a little too long, so I had to add a gasket on the front to pull the movement back a couple of mm. The only problem with that is now the plastic "catches" don't really lock down the movement properly. Oh well, at least it finally works!

'nuff said