this stock exhaust sounds pretty sweet. what did he do to it?

anoopb · June 13, 2013, 03:12:35 PM

http://www.youtube.com/watch?v=5S2ecFOA8jc

any ideas? does it only sound nice because of the camera microphone?

anyone else done whatever it is he's done to it?

weedahoe · June 13, 2013, 04:23:32 PM

A microphone can make all the difference. Open exh usually means nothing in the pipe or muffler restricting air flow

See post #17 in this thread

http://gstwins.com/gsboard/index.php?topic=63049.0

jacob92icu · June 13, 2013, 04:42:01 PM

Pretty sure he just cut out the round inner circle that you can see inside the end of the exhaust.

anoopb · June 14, 2013, 06:57:52 AM

Quote from: jacob92icu on June 13, 2013, 04:42:01 PM
Pretty sure he just cut out the round inner circle that you can see inside the end of the exhaust.

i'd think that would be pretty hard to do. isn't it a very long piece (the length of the sleeve?)

do you guys recommend doing this? or is it not worth it?

Soloratov · June 14, 2013, 07:08:43 AM

No, he means just the tip of the inner tube, so that it is flush with the inside of the outer can. Can be done easily with a dremel. Makes it just a little louder without doing anything to the inside.

anoopb · June 14, 2013, 08:05:03 AM

Quote from: Soloratov on June 14, 2013, 07:08:43 AM
No, he means just the tip of the inner tube, so that it is flush with the inside of the outer can. Can be done easily with a dremel. Makes it just a little louder without doing anything to the inside.

Ah i see. i may give this a try.

thanks!

Tallemertes · June 14, 2013, 09:14:51 AM

Would you need to rejet after doing this?

jacob92icu · June 14, 2013, 01:47:37 PM

No need to rejet. my guess is the further you cut, the throatier it will sound.

MNgs500 · June 14, 2013, 04:45:26 PM

I did this and cut the inner pipe flush i used a cutting stone on a dremel only took three blades to go through

Sent from GS3

Tallemertes · June 15, 2013, 07:38:05 AM

Quote from: MNgs500 on June 14, 2013, 04:45:26 PM
I did this and cut the inner pipe flush i used a cutting stone on a dremel only took three blades to go through

Sent from GS3

Are you happy with the result? How much did it change the exhaust tone?

anoopb · June 15, 2013, 08:43:56 AM

Quote from: Tallemertes on June 15, 2013, 07:38:05 AM
Quote from: MNgs500 on June 14, 2013, 04:45:26 PM
I did this and cut the inner pipe flush i used a cutting stone on a dremel only took three blades to go through

Sent from GS3
Are you happy with the result? How much did it change the exhaust tone?

i too am curious about it. would you recommend it?

News:

this stock exhaust sounds pretty sweet. what did he do to it?