News:

Need a manual?  Buy a Haynes manual Here

Main Menu

New Break pads!!!

Started by robfriedenberger, September 25, 2013, 01:07:54 PM

Previous topic - Next topic

robfriedenberger

Hey guys this should be an easy one for you guys who have been around the block once or twice with these bikes.

I ordered a new set of EBC Break pads and rotors for the front and rear, I've changed breaks before on many different cars, even my 74 yamaha but i was wondering what the peferred method of compressing the piston back into the caliper. To do this on my yamaha i had to rebuild the caliper each time with new crush rings and gaskets.

Thanks

yamahonkawazuki

on my gs' in times past, id remove the caliper, remove pad, turn it around, facing caliper piston, and using a c clamp, compress VERY slowly. im sure ill be corrected for doing this. but have never had any issues
Jan 14 2010 0310 I miss you mom
Vielen dank Patrick. Vielen dank
".
A proud Mormon
"if you come in with the bottom of your cast black,
neither one of us will be happy"- Alan Silverman MD

007brendan

#2
If they're not too gunked up, they're small enough to be compressed by hand.  Using a small piece of wood or a screwdriver can help. No need to rebuild
"Good judgement comes from experience. Experience comes from bad judgement."

gsJack

I pop pistons out and clean them and they push back in by hand.  Easy bleed if you do it right.  Previously I had front wheel lock-up a couple times and it was difficult to get home to fix.  Winter riding really builds up some hard crud on the brake pistons.  I clean pistons with those green kitchen pads until crud is all off.
407,400 miles in 30 years for 13,580 miles/year average.  Started riding 7/21/84 and hung up helmet 8/31/14.

Funderb

Before i took the old pads out:
1. Stick any strong metal object in
2. Pry until cylinders are back in their original places
3. try not to bump the brake lever.

Ta daa
No bleeding necessary.
Black '98 gs500 k&n Lbox, akrapovic slip-on, kat600 shock, progressive sproings, superbike handlebars, 40/147.5/3.5washers

"I'd rather ride then spend all my time fiddling trying to make it run perfectly." -Bombsquad

"Never let the destination cast a shadow over your journey towards it- live life"

Twism86

Im sorry but i have to... Its brake pads. Cars and motorcycles have brakes, not breaks. Sorry for being a grammar nazi.

As said before me, just stick a flat head screw driver in between the old pads and push them apart before installing the new ones. Done.
First bike - 2002 GS500E - Sold
Current - 2012 Triumph Street Triple R
"Its more fun to ride a slow bike fast than a fast bike slow"

Tom

gsJack

Just push them back in can work for the fair weather riders for quite a long time but sooner or later they'll get burned.  Best to make sure the pistons are clean before pushing them back in because there is nothing but the deflected o-rings to retract them after brakes are repeatedly applied and release in use and they will get a little tighter with each application until the wheel will no longer turn if they are stuck in the wipers.  Maybe my little Suzi just drinks too much salt water.   :dunno_black:
407,400 miles in 30 years for 13,580 miles/year average.  Started riding 7/21/84 and hung up helmet 8/31/14.

cbrfxr67

"Its something you take apart in 2-3 days and takes 10 years to go back together."
-buddha

robfriedenberger

Thanks guys for all the input!

Life is to short to care about other peoples spelling and grammar. 

Thanks!

SMF spam blocked by CleanTalk