Recently I have been doing custom work for a local bike shop, and have been asked about fabricating custom swing arm end plates for a number of bikes. Many do not come with center stands, and that creates an obvious issue when trying to work on the rear of the bike. The solution is this set of plates.

They will come as brushed aluminum finish, or powder coated black. The sides are tapped M8 thread to accept a wide variety of sliders, jack rollers, license plate mounts, etc. The back of the plates are stepped to set into the swing arm, and the adjuster bolt run through as stock.

Custom CNC machined, billet aluminum. Easy install, no modifications required. Simply unbolt the old plates, push these into the swing arm and tighten the two screws. Then replace the adjuster nut. At this point you can attach anything you want to the plates.

MaddTraxxRC Swingarm End Plates:

Aluminum finish:$38/pair
Black Finish: $42/pair



Shipping inside the US is flat rate USPS. International will be quoted upon request.

Very nice idea.

THe design and process is all set. These will now be for sale with a 2 day lead time.

Here is a shot mounted on a Honda CTX.