Does anyone have access to, or know anyone with access to, a mandrel bender? I need some exhaust tubing bent (1 7/8"). Heck, I even need the tubing itself.

It shouldn't be more than about 25" long and bent into a "J" shape. I need two of them. Trying to eliminate some drone that's caused by the new cat-back exhaust I installed on my Mustang.

Not sure if it's helpful but my boss had a v8 here in Australia with twin exhausts on it.  He had what sounds like a similar problem.  When just cruising it had a horrible drone.  The exhaust place has joined the pipes at what looks like slightly offset lengths after the silencers.  Still sounds like a million bucks but the drone is history.

M

Have you checked out Cone Engineering?

http://www.coneeng.com/

I've ordered from them a couple times and wasn't disappointed.

Quote from: marcusk on April 26, 2016, 02:37:23 AM
Not sure if it's helpful but my boss had a v8 here in Australia with twin exhausts on it.  He had what sounds like a similar problem.  When just cruising it had a horrible drone.  The exhaust place has joined the pipes at what looks like slightly offset lengths after the silencers.  Still sounds like a million bucks but the drone is history.

M

Quote from: Big Rich on April 26, 2016, 04:15:34 AM
Have you checked out Cone Engineering?

http://www.coneeng.com/

I've ordered from them a couple times and wasn't disappointed.

Thanks guys. I want to also eliminate some raspiness that the exhaust has, so I ordered some resonators. I'm going to weld those in-line right before the mufflers themselves. This should (hopefully) ALSO reduce the drone. If not, I'll revisit this idea.