Get your machinist to deck that top surface and clean up the long edges to remove the stock ink/wear.   It will look just like the short edge....no further finishing necessary.

400 grit paper will take it off in seconds, spray wd40 and do with 1000 and then 2000 and then steel wool and it looks like a mirror.
I think decking it is a bit radical ... Lemme do this to 1 and see how much work it is. I may just do em all, setting up for the job is 90% of the work, get that done and you might as well do em all.
Cool.
Buddha.

Fresh set of these are back.
Very cool, its my favorite mod if you got stock forks. I did this to my 89, 2 months after buying it in 95. I always ran one on mine till I went kat FE crazy.

$40 shipped in US, and will combine with other stuff for $5 off shipping ... so $35 with other bigger stuff. Even your carbs ... But well, logically, the smaller object will ship free of course. Say you buy jets and this, you get $2 0ff its shipping but pay shipping on the bigger stuff.

Cool.
Buddha.

PM'ng you.

These are available as well. Just had a dozen made. Sold 2 so 10 left.
Order with other things and you only pay shipping for the largest item. Smaller ones ride free.
Cool.
Buddha.

do you have this now to ship??  i need them in 2 weeks. if that is possible i will buy. i will send pm.

Got 10 sitting in a box with both sizes of stock like bolts in stainless and longer to fit ...
OK 9 after yours is sent.
Remember though that pic was one that was sanded a bit. It may be dirtyier, but a 2 min sanding with 400-1000 grit will get it shiny.
Cool.
Buddha.

I got one and I like it, would recommend.

Gotta sell em to raise $$$ for the case guards.
Cool.
Buddha.

Buddha, PM'd.

Still have some left Buddha?

-Jessie

Yes I do.
I'll post saying 1-2 left and all gone, more to be made etc etc as the stock runs low/out.
Cool.
Buddha.

Any quantity discounts??   

-Jessie

Thank you sir. arrived today.  After a few sanding.. this baby should shine. 

I want one. will PM in a moment.

Quote from: BaltimoreGS on September 14, 2009, 09:35:18 AM
Any quantity discounts??   

-Jessie

10 for say $320 and mailing (if its 1 address I mail to, I'll mail it free cos it will get into a USPS $10 box), but I have to make some more then, so it may be a short wait. I got the material though, so may be very short wait.

Bluehaze - I got a very clean first set. Your brace came from a set that was pretty dirty. Sorry. But of course sanding it will get it all out dirt and the printing etc etc.

Cool.
Buddha.

So these will cut out any 'weave' thru fast sweeping corners when bike is being 'ridden hard' ?  & stabilize the front end in general ? Yes ?

& any still in stock?   If so, would you post to Australia, NSW, 236 ?  & at what cost ?

Thanks

Yes in stock, and shipping is ~$12 to australia ... make that ~$13. Yea got some ugly forms to fill whihc I will do, patience is one of my virtues.

Weave ... well, it usually has its biggest effect under braking I feel. So if your problem is worse under braking than when not, it would make the 2 about equal if that makes sense.

Anyway, I'd send to Au for 48 USD shipped.
Cool.
Buddha.

^^^^ Sweet as Buddha.....PM some banking details, & I will get the money to you ASAP .

Cheers

Hey Buddha,

Do you have any of these left? PM me with details.

Thanks