That's the piece that goes in the middle of a roll of tape in a desk tape dispenser, enabling it to spin and feed as one pulls.

Quote from: jdoorn14 on January 08, 2013, 07:34:10 AM
That's the piece that goes in the middle of a roll of tape in a desk tape dispenser, enabling it to spin and feed as one pulls.

Good work.  Your turn!

Sorry, I didn't get a chance to take a pic until this morning.

Here we go:

looks like the holding ring off of a large mouthed drink bottle :p

Random plastic part #2945850495069593949595868400320

A dime!

A spacer or liner inside a connector to protect wires from getting scraped or damaged by the connector.

Crazydood, you're close, but adidasguy is closer. Neither is correct, though.

Adidasguy is on the right track, but not for wires & such.

Maybe I was too nice by using a dime for scale?

In a compression fitting for a pipe/tube/hose

Does it go around some sort of glass tube for packing so that it doesn't bump and break?

Adidasguy is closest with his compression fitting idea. I'll call that close enough, because I don't think anyone could guess the actual item.

It is a rubber gasket that stretches to fit around the enclosure of a little clock (think watch-size) allowing it to fit into a decorative enclosure without movement.

It goes on like this:





Allowing the clock to fit into this:

Quote from: adidasguy on January 09, 2013, 02:57:12 PM
In a compression fitting for a pipe/tube/hose

This was my first thought too, but I was thrown off by the ribs on the outside.  If it were a compression fitting for plumbing, it would look just like that without the ribs.

i was going to say,...



but then saw the dime,...so thought,....maybe,...

Oh why haven't I seen this thread before.....

Here is one for you guys...




I may have made this one too easy...

Quote from: cbrfxr67 on January 10, 2013, 10:33:37 AM


but then saw the dime,...so thought,....maybe,...

LOLs... I thought this too, but I feared the Tard Farm if I brought the thread there... but good thought on the images to say it

- Bboy

Quote from: BockinBboy on January 10, 2013, 11:03:22 AM
LOLs... I thought this too, but I feared the Tard Farm if I brought the thread there... but good thought on the images to say it

- Bboy

OMG ----

So it was Manaenrc that got it? I must have missed his guess.

Quote from: Manaenrc on January 10, 2013, 10:47:02 AM
Oh why haven't I seen this thread before.....

Here is one for you guys...




I may have made this one too easy...

Chip puller for electronics (PCs mainly) before the ZIF (Zero Insertion Force) socket.

Still didn't see where he won.
Did the rules of the game change?
Rules were winner picks the next challenge.
Oh, well. Never mind.

Oh, sorry....

Go ahead and post up a new one Adidasguy, I think Manaenrc just confused the rules.

To Manaenrc: Check the first post in the thread.
No harm, no foul.. lets just get back to the game!

- Bboy